Key Features:

- No of Pages: 23

- No of chapters: 05

Buy Now

Introduction:

Abstract

The design and construction of s refrigerating unit is handled from the knowledge of the working principles of laws of thermodynamics.

The size of the containing vessel i.e the case as established to be of 45cm by 32 cm in dimension. The Angle iron mild steel to used in the fabrication and welding. The box case of two layers are fabricated. Plastic (cooler) box is then placed inside the upper part with the other parts of the refrigerator were brought in. they were all fixed onto a wooden base with all the connections (electrical) made.

The capacity of the refrigerator is based on the workdone by the compressor which is O.I hp in specification. The size of the components used are

i. Condenser: The size is 0.1hp and it is a plate type condenser with extended surface.

ii. Compressor: The size is 0.1hp (75 watts)

iii. Copper wire: it is of 0.5cm in diameter and the total copper wire length is about 600cm (1½ roll)

The introduction of cooling fluid and filling of the compressor enabled the compressor to start functioning when connected to electricity using a 13 AMP rated socket

The interior of the plastic box is lined with dominium box with tubes arranged in convolution around it. This world effectively and cooled the water dropped into it. It compares favorably with the ones in the market.

Table of Content

TITLE PAGE

LETTER OF TRANSMITTAL

APPROVAL/CERTIFICATION

DEDICATION

ACKNOWLEDGEMENT

ABSTRACT

TABLE OF CONTENT



CHAPTER ONE

1.0 INTRODUCTION

1.1 SCOPE OF THE PROJECT



CHAPTER TWO

HISTORY OF REFRIGERATION

TYPES OF REFRIGERATING DEVICE

USES OF REFRIGERATION





CHAPTER THREE

SEQUENCE OF OPERATIONS

SELECTION OF REFRIGERANTS

CONSTRUCTION PROCEDURE

ECONOMIC ANALYSIS



CHAPTER FOUR

4.1 CONCLUSION

4.2 RECOMMENDATIONS

REFERENCES.

Introduction

The introduction of this research is only available in the paid version.