Key Features:
- No of Pages: 43
- No of Chapters: 07
Introduction:
Abstract
The aim of this project was to construct shell and tube heat exchanger with fixed boundless. A heat exchanger that would cool 5 x 5 x 10 x 3 kg/s of steam at a calculated heat load of 152395/S was fabricated. The steam is to reach the heat exchanger from a distillation column at a temperature of 300k. The specification of the layout as well as the detailed mechanical design were assumed and also calculated.
rnIt is established that a horizontal heat exchanger with cold water at the shall side and the treated steam at the tube side is adequate for this operation, with the aim of cooling the steam from the distillation column.
rn The available area obtained from calculation is 1.0m2 and also the overall heat transfer coefficient obtained is 4.10W/M2k. it is also seen that the heat exchanger is satisfactory and consists of five copper tubes of inside diameter 90mm and 5920mm length. The shell inside diameter 810mm and 5.770mm length. The tube and shell heat exchanger has a total length of 5820mm.
rnThe material of construction for the shell side is stainless steel while copper tubes were used for the tubes inside.
rnThe total cost of the heat exchanger was N12,000.
Table of Content
Title Page
rnApproval page
rnLetter of transmitted
rnDedication
rnAcknowledgements
rnAbstract
rnTable of contents
rn
rnCHAPTER ONE
rn1.1Introduction
rn
rnCHAPTER TWO
rn2.0Literature Review
rn2.1General Design of Heat Exchanger
rn2.2Tubular Heat Exchanger
rn2.3Design Description of the Major Components
rn2.4Tubes
rn2.5Tube Bundles
rn2.6Shells
rn2.7Baffle
rn2.8Tie Road Spacers
rn2.9Pass Partition Plates
rn
rnCHAPTER THREE
rn3.0Fabrication Procedures
rn3.1Dimensioning and Marking Out
rn3.2Cutting
rn3.3Folding or Rolling
rn3.4Drilling operation
rn3.5Assembling Process
rn3.6Welding Operation
rn3.7Filling
rn3.8Dimensions and Parameters Derived
rn3.9From the Fabrication Units
rn
rn
rnCHAPTER FOUR
rn4.0Costing
rn
rnCHAPTER FIVE
rn5.0Discussion
rn
rnCHAPTER SIX
rn6.0Conclusion
rn6.1Recommendations
rn
rnCHAPTER SEVEN
rn7.0Notation and Nomenclature
rnReferences
rnAppendix
rnPhysical Properties of Water
rnCalculation of the Head Load
Introduction
The introduction of this research is only available in the paid version.
Buy Now
