Key Features:

- No of Pages: 73

- No of Chapters: 06

Buy Now

Introduction:

Abstract

The main objective of this project was to ensure a proper security to car being parked in garage against theft or an intruder. The circuit uses three NE555 timers; one of the NE555 was wired as a monostable oscillator and remaining two were wired as tone generator and amplified to obtain a maximum audible sound. However, pin 2 of the first NE555 was used as sensor part .When pin 2 has contact with human body or hand it will activate the IC1 which will also bias transistor and this transistor was wired in a way that once it is powered it will close circuit thereby passing a negative supply voltage to tone generator circuit and outputted out through a loud speaker or buzzer.

This device functions as a major security device against car-theft as stated above. It is an electronic device that is connected to the battery of the car it is being installed in and gets activated when the car engine is switched off and the car stationed at a place. The device is not seen but, it has an indicator light which shows that the alarm has been activated. When the body of the car is touched by human hand, it sends a negative signal to the device which needs a negative pulse to get activated; it sends this negative from the human hand to the tone generator IC which triggers the alarm.

Table of Content

Title Page

Certification

Dedication

Acknowledgement

Abstract

Table of content

List of Symbols



CHAPTER ONE:

Introduction

1.1 Background of study

1.2 Aims and objectives



CHAPTER TWO:

Literature Review



CHAPTER THREE:

Specification and operation of system component

3.1 Description of NE55 Timer

3.2 Description of Resistor

3.3 Description of Capacitor

3.4 Description of Diode

3.5 Description of Transformer

3.6 Description of Loud Speaker and Buzzer

3.7 Description of Transistor

3.8 Description of L.E.D



CHAPTER FOUR:

Operation of system and its circuit and block diagram

4.1 Operation of circuit

4.2 The circuit diagram

4.3 The block diagram



CHAPTER FIVE:

Construction, Testing and Packaging

5.1 Values of components

5.2 Assembly

5.3 A schematic diagram of the finished work



CHAPTER SIX:

Conclusion and Recommendation

6.1 Conclusion

6.2 Recommendation

6.3 Observations

6.4 Difficulties

6.5 References

Introduction

The introduction of this research is only available in the paid version.